Miter Box with Back Saw

The Zeptix Supplies Miter Box with Back Saw gives you accurate angle cuts in trim, molding, and small stock without the noise, dust, or setup time of a power miter saw. The miter box is crafted from kiln-dried hardwood with precisely machined slots at 90, 45, and 22.5 degrees on both sides, plus an open front that accepts wide crown molding laid flat. Brass wear plates line every guide slot to prevent the saw from widening the kerf over years of use, a detail that separates this box from disposable plastic alternatives. The included fourteen-inch back saw has a rigid steel spine that keeps the blade from flexing in the cut, and the fourteen-tooth-per-inch rip-crosscut pattern handles both soft and hardwoods cleanly. The saw’s turned hardwood handle matches the box, and the full kit stores together in a compact footprint on a shelf or in a job-site crate. Perfect for baseboard, chair rail, picture frames, and any miter joint under five inches wide. A manual-tool solution that delivers power-tool-quality cuts at a fraction of the cost, dust, and noise.